CyberPower PDU15SW8RNET Uživatelský manuál stáhnout pdf (Strana 30)

PowerPanel™ Business Edition

Battery Test

The Battery Test performs a battery test to verify that the batteries are good, and shows information

including the result and the date of the last battery test. Click the Initiate button to begin a battery test.

Performing a battery test is prohibited when the Frequency Working Mode option is set to fixed.

The results will be reported after a battery test completes:

z Last Test Date: The date the last battery test was performed.

z Last Test Result: The result of the last battery test:

 Passed: The battery performed normally during the test.

 None: The UPS has never performed the battery test.

 Failed: The battery test resulted in failure.

Follow the below steps if the battery test fails:

z Repeat the battery test and replace the batteries if the test fails again.

z Contact CyberPower for assistance if the battery test fails after the batteries have been replaced.

Runtime Calibration

The Runtime Calibration ensures the runtime estimate is accurate with the current load. The results show

the runtime, the result, and the date of the last calibration. When a runtime calibration is initiated, the

connected equipment will be run on battery power until the batteries are completely discharged. The

batteries will be then automatically recharged following the calibration.

Users can click the Start button to initiate a runtime calibration. Click the Cancel button to interrupt the

runtime calibration. The result will be reported after a calibration is finished or canceled:

z Estimated Runtime: The estimated runtime of the batteries.

z Last Calibration Result: The result of the last runtime calibration.

 Passed: The runtime calibration completed and the batteries are good.

 None: The UPS has never performed a runtime calibration.

 Failed: The UPS failed during the runtime calibration.

 Canceled: The calibration was interrupted.

z Last Calibration Date: The date the last runtime calibration was performed.

Note: It is recommended to perform at least one calibration every 3 months.

Note: A complete calibration causes the battery capacity to deplete, Ensure the UPS is recharged

completely after performing a calibration.

Alarm Test

The Alarm Test allows users to verify that the alarm can beep normally and shows the date of the last test.

Click the Initiate button to begin an alarm test.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 99 100

Žádné komentáře

CyberPower PDU15SW8RNET Uživatelský manuál Strana 30