CyberPower PDU20SW8RNET Uživatelský manuál stáhnout pdf (Strana 47)

 ATS: Indicates the computer is plugged in an ATS.

 Network PDU: Indicates the computer is plugged in one single PDU with network function.

 UPS with Network PDU: Indicates the computer is plugged in a network PDU, which is a power extension

from the UPS.

 UPS with Generic PDU: Indicates the computer is plugged in a generic PDU, which has no network function

and is a power extension from the UPS.

 UPS Address: Assigns the network address of the UPS. Enter the IP address or use the pull down to show the

device list and select a device address from the list. Clicking the refresh button (the icon with the rotating arrow)

causes to search the network to update the results. If a UPS communicates with a computer that has been

installed PowerPanel Business Edition Agent, assign the IP address of the computer as the UPS network address.

This option appears when power connection is set up making computer connect to UPS directly.

When the power of a computer is configured to connect to an ATS, two UPS addresses will appear to be assigned.

Any one of input source of ATS is being supplying power by a UPS, the network address of UPS should be

assigned. An UPS address, which is set blank, indicates that the input source of ATS did not connect to an UPS.

Move the cursor over the target address to display details about the device

The computer searches the device with the least uptime to be a default device after an installation. One available

outlet will be assigned to connect automatically with the computer. If no outlet is available, the first critical-load

outlet will be assigned to be used by a computer.

The uptime of the devices indicates the length of time that the device has been functioning. When the computer

scans the network, the device with shortest uptime will be marked a yellow star icon. You can press the

Reset button for 1 second to reset the uptime of device to have the top priority. Do not press the reset button for

more than 4 seconds. Otherwise, it will be recognized as a complete configuration reset demand.

Clicking the refresh button to search all devices again on the local network

 PDU Address: Assigns the network address of the PDU. Enter the IP address or use the pull down to show the

device list and select a device address from the list. Clicking the refresh button (the icon with the rotating arrow)

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 132 133

Žádné komentáře

CyberPower PDU20SW8RNET Uživatelský manuál Strana 47